=== START OF INFORMATION SECTION ===
Model Family:     Seagate Barracuda Green (Adv. Format)
Device Model:     ST2000DL003-9VT166
Serial Number:    6YD21HH8
LU WWN Device Id: 5 000c50 046df7ccd
Firmware Version: CC3C
User Capacity:    2 000 398 934 016 bytes [2,00 TB]
Sector Sizes:     512 bytes logical, 4096 bytes physical
Device is:        In smartctl database [for details use: -P show]
ATA Version is:   8
ATA Standard is:  ATA-8-ACS revision 4
Local Time is:    Sun Mar 23 04:18:08 2014 MSK
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Offline data collection status:  (0x82) Offline data collection activity
                                        was completed without error.
                                        Auto Offline Data Collection: Enabled.
Self-test execution status:      (   0) The previous self-test routine completed
                                        without error or no self-test has ever
                                        been run.
Total time to complete Offline
data collection:                (  623) seconds.
Offline data collection
capabilities:                    (0x7b) SMART execute Offline immediate.
                                        Auto Offline data collection on/off support.
                                        Suspend Offline collection upon new
                                        command.
                                        Offline surface scan supported.
                                        Self-test supported.
                                        Conveyance Self-test supported.
                                        Selective Self-test supported.
SMART capabilities:            (0x0003) Saves SMART data before entering
                                        power-saving mode.
                                        Supports SMART auto save timer.
Error logging capability:        (0x01) Error logging supported.
                                        General Purpose Logging supported.
Short self-test routine
recommended polling time:        (   1) minutes.
Extended self-test routine
recommended polling time:        ( 255) minutes.
Conveyance self-test routine
recommended polling time:        (   2) minutes.
SCT capabilities:              (0x30b7) SCT Status supported.
                                        SCT Feature Control supported.
                                        SCT Data Table supported.

SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE      UPDATED  WHEN_FAILED RAW_VALUE
  1 Raw_Read_Error_Rate     0x000f   119   084   006    Pre-fail  Always       -       96368
  3 Spin_Up_Time            0x0003   093   092   000    Pre-fail  Always       -       0
  4 Start_Stop_Count        0x0032   100   100   020    Old_age   Always       -       115
  5 Reallocated_Sector_Ct   0x0033   100   100   036    Pre-fail  Always       -       0
  7 Seek_Error_Rate         0x000f   066   060   030    Pre-fail  Always       -       17196193719
  9 Power_On_Hours          0x0032   078   078   000    Old_age   Always       -       19829
10 Spin_Retry_Count        0x0013   100   100   097    Pre-fail  Always       -       0
12 Power_Cycle_Count       0x0032   100   100   020    Old_age   Always       -       84
183 Runtime_Bad_Block       0x0032   100   100   000    Old_age   Always       -       0
184 End-to-End_Error        0x0032   100   100   099    Old_age   Always       -       0
187 Reported_Uncorrect      0x0032   001   001   000    Old_age   Always       -       714
188 Command_Timeout         0x0032   100   100   000    Old_age   Always       -       0
189 High_Fly_Writes         0x003a   100   100   000    Old_age   Always       -       0
190 Airflow_Temperature_Cel 0x0022   055   046   045    Old_age   Always       -       45 (Min/Max 29/47)
191 G-Sense_Error_Rate      0x0032   100   100   000    Old_age   Always       -       0
192 Power-Off_Retract_Count 0x0032   100   100   000    Old_age   Always       -       65
193 Load_Cycle_Count        0x0032   100   100   000    Old_age   Always       -       141
194 Temperature_Celsius     0x0022   045   054   000    Old_age   Always       -       45 (0 21 0 0)
195 Hardware_ECC_Recovered  0x001a   033   003   000    Old_age   Always       -       96368
197 Current_Pending_Sector  0x0012   086   086   000    Old_age   Always       -       1192
198 Offline_Uncorrectable   0x0010   086   086   000    Old_age   Offline      -       1192
199 UDMA_CRC_Error_Count    0x003e   200   200   000    Old_age   Always       -       1
240 Head_Flying_Hours       0x0000   100   253   000    Old_age   Offline      -       96537979923439
241 Total_LBAs_Written      0x0000   100   253   000    Old_age   Offline      -       660774676
242 Total_LBAs_Read         0x0000   100   253   000    Old_age   Offline      -       1381257330

SMART Error Log Version: 1
ATA Error Count: 714 (device log contains only the most recent five errors)
        CR = Command Register [HEX]
        FR = Features Register [HEX]
        SC = Sector Count Register [HEX]
        SN = Sector Number Register [HEX]
        CL = Cylinder Low Register [HEX]
        CH = Cylinder High Register [HEX]
        DH = Device/Head Register [HEX]
        DC = Device Command Register [HEX]
        ER = Error register [HEX]
        ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.

Error 714 occurred at disk power-on lifetime: 19733 hours (822 days + 5 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 00 ff ff ff 0f  Error: UNC at LBA = 0x0fffffff = 268435455

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  25 00 00 ff ff ff ef 00  20d+08:13:24.246  READ DMA EXT
  27 00 00 00 00 00 e0 00  20d+08:13:24.245  READ NATIVE MAX ADDRESS EXT
  ec 00 00 00 00 00 a0 00  20d+08:13:24.237  IDENTIFY DEVICE
  ef 03 46 00 00 00 a0 00  20d+08:13:24.214  SET FEATURES [Set transfer mode]
  27 00 00 00 00 00 e0 00  20d+08:13:24.161  READ NATIVE MAX ADDRESS EXT

Error 713 occurred at disk power-on lifetime: 19733 hours (822 days + 5 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 00 ff ff ff 0f  Error: UNC at LBA = 0x0fffffff = 268435455

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  25 00 00 ff ff ff ef 00  20d+08:13:11.589  READ DMA EXT
  27 00 00 00 00 00 e0 00  20d+08:13:11.588  READ NATIVE MAX ADDRESS EXT
  ec 00 00 00 00 00 a0 00  20d+08:13:11.580  IDENTIFY DEVICE
  ef 03 46 00 00 00 a0 00  20d+08:13:11.557  SET FEATURES [Set transfer mode]
  27 00 00 00 00 00 e0 00  20d+08:13:11.548  READ NATIVE MAX ADDRESS EXT

Error 712 occurred at disk power-on lifetime: 19733 hours (822 days + 5 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 00 ff ff ff 0f  Error: UNC at LBA = 0x0fffffff = 268435455

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  25 00 00 ff ff ff ef 00  20d+08:13:04.712  READ DMA EXT
  27 00 00 00 00 00 e0 00  20d+08:13:04.711  READ NATIVE MAX ADDRESS EXT
  ec 00 00 00 00 00 a0 00  20d+08:13:04.703  IDENTIFY DEVICE
  ef 03 46 00 00 00 a0 00  20d+08:13:04.696  SET FEATURES [Set transfer mode]
  27 00 00 00 00 00 e0 00  20d+08:13:04.659  READ NATIVE MAX ADDRESS EXT

Error 711 occurred at disk power-on lifetime: 19733 hours (822 days + 5 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 00 ff ff ff 0f  Error: UNC at LBA = 0x0fffffff = 268435455

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  25 00 00 ff ff ff ef 00  20d+08:12:59.016  READ DMA EXT
  27 00 00 00 00 00 e0 00  20d+08:12:59.015  READ NATIVE MAX ADDRESS EXT
  ec 00 00 00 00 00 a0 00  20d+08:12:59.007  IDENTIFY DEVICE
  ef 03 46 00 00 00 a0 00  20d+08:12:58.999  SET FEATURES [Set transfer mode]
  27 00 00 00 00 00 e0 00  20d+08:12:58.959  READ NATIVE MAX ADDRESS EXT

Error 710 occurred at disk power-on lifetime: 19733 hours (822 days + 5 hours)
  When the command that caused the error occurred, the device was active or idle.

  After command completion occurred, registers were:
  ER ST SC SN CL CH DH
  -- -- -- -- -- -- --
  40 51 00 ff ff ff 0f  Error: UNC at LBA = 0x0fffffff = 268435455

  Commands leading to the command that caused the error were:
  CR FR SC SN CL CH DH DC   Powered_Up_Time  Command/Feature_Name
  -- -- -- -- -- -- -- --  ----------------  --------------------
  25 00 00 ff ff ff ef 00  20d+08:12:47.883  READ DMA EXT
  27 00 00 00 00 00 e0 00  20d+08:12:47.882  READ NATIVE MAX ADDRESS EXT
  ec 00 00 00 00 00 a0 00  20d+08:12:47.875  IDENTIFY DEVICE
  ef 03 46 00 00 00 a0 00  20d+08:12:47.851  SET FEATURES [Set transfer mode]
  27 00 00 00 00 00 e0 00  20d+08:12:47.726  READ NATIVE MAX ADDRESS EXT

SMART Self-test log structure revision number 1
Num  Test_Description    Status                  Remaining  LifeTime(hours)  LBA_of_first_error
# 1  Extended offline    Completed: read failure       90%     19731         3189109384
# 2  Short offline       Completed: read failure       90%     19731         3184389160
# 3  Extended offline    Aborted by host               90%      3258         -
# 4  Short offline       Completed without error       00%      3258         -

SMART Selective self-test log data structure revision number 1
SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS
    1        0        0  Not_testing
    2        0        0  Not_testing
    3        0        0  Not_testing
    4        0        0  Not_testing
    5        0        0  Not_testing
Selective self-test flags (0x0):
  After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.