всем привет вообщем купил сетевую карту " http://www.ulmart.ru/goods/154988 " и не могу утсановить драйвера не знаю как и что делать с ними вот они все http://clip2net.com/s/5FTuzv пишу команду make пишет что нету конфигурации для установки...
в ридми вот что
This is the Linux device driver released for RealTek Ethernet controllers, which are listed as following.
1. RTL8169S/SB/SC (Gigabit Ethernet with PCI interface)
2. RTL8168B (Gigabit Ethernet with PCI-Express interface)
3. RTL8101E (Fast Ethernet with PCI-Express interface)
<Requirements>
- kernel source tree (supported versions 2.4.x or 2.6.x)
- compiler/binutils for kernel compilation
<Quick install with proper kernel settings>
Unpack the tarball :
unzip r1000_linuxdrv_vxx.zip
Change to the directory:
cd r1000
If you are running the target kernel, then you should be
able to do :
make clean modules (as root or with sudo)
make install
depmod -a
<Force Media Speed>
The media can be forced to one of the 5 modes as follows.
Cmd: "insmod r1000 media = SET_MEDIA"
For example:
"insmod r1000 media = 0x04" will force PHY to operate in 100Mpbs Half-duplex.
SET_MEDIA can be:
_10_Half = 0x01
_10_Full = 0x02
_100_Half = 0x04
_100_Full = 0x08
_1000_Full = 0x10
Force media type for multiple cards could be performed as:
"insmod r1000 media=0x04,0x10"
which force PHY to operate at 100Mbps half-duplex and 1000Mbps full-duplex.
<Advanced feature>
- Supports Jumbo Frame
- Hardware Tx/Rx flow control
объясните что и как делать я чайник в таких делах =)))
